Changeset 202 in xtideuniversalbios for trunk/XTIDE_Universal_BIOS_Configurator_v2/Inc/Help


Ignore:
Timestamp:
Nov 22, 2011, 2:08:32 PM (13 years ago)
Author:
krille_n_@…
google:author:
krille_n_@hotmail.com
Message:

Changes:

  • Library/BIOS: Minor optimizations to DisplayFormatCompressed.asm and BootMenuEvent.asm
  • XTIDECFG: Trimmed trailing CRLFs from some of the text files in Help (also fixed a typo)
Location:
trunk/XTIDE_Universal_BIOS_Configurator_v2/Inc/Help
Files:
3 edited

Legend:

Unmodified
Added
Removed

  • trunk/XTIDE_Universal_BIOS_Configurator_v2/Inc/Help/Bootmenu_SerialDetect.txt

    r200 r202  
    11Set to Yes, at the end of normal drive detection, COM ports 1-7 (in reverse order) will be scanned for a connection to a serial drive server. This option provides flexibility with the COM port and baud rate to be used, it need not be configured ahead of time, but at the expense of a slower boot process. Even when this option is set to No, this functionality can still be invoked by holding down the ALT key at the end of normal drive detection. Note that if any serial drives are detected during the normal drive detection, no scan will take place (to avoid finding the same drive twice).
    2 

  • trunk/XTIDE_Universal_BIOS_Configurator_v2/Inc/Help/IDE_SerialBaud.txt

    r199 r202  
    11Supported baud rates are 2400, 9600, 38.4K, and 115.2K. The server must also be set to this same speed. Older UARTs may only support 2400 and 9600 baud, but sometimes can be pushed to 38.4K. 115.2K will likely only be possible with a newer UART that inclues a FIFO. Some high speed serial ports include UART clock multipliers, allowing for speeds at 230.4K (2x multiplier) and 460.8K (4x multiplier). These high speeds are supported by these BIOS, even on original 4.77MHz 8088 systems. Note that UART clock multipliers are not detectable by the software and 115.2K will still be used during configuration for high speeds; but if a multiplier is used, the actual speed (including the multiplier) will need to be used on the server.
    2 
    3 

  • trunk/XTIDE_Universal_BIOS_Configurator_v2/Inc/Help/IDE_SerialPort.txt

    r199 r202  
    1 Select a serial port by I/O address. Supported values are between 240h and 438h, and must be on an 8-byte boundary. If the entered value corresponds to one fo the established COM port numbers, then the selection of serial port will use COM numbers instead.
     1Select a serial port by I/O address. Supported values are between 240h and 438h, and must be on an 8-byte boundary. If the entered value corresponds to one of the established COM port numbers, then the selection of serial port will use COM numbers instead.
Note: See TracChangeset for help on using the changeset viewer.