source: xtideuniversalbios/trunk/XTIDE_Universal_BIOS/Src/Device/Serial/SerialDPT.asm@ 361

; Project name  :   XTIDE Universal BIOS
; Description   :   Sets Serial Device specific parameters to DPT.

; Section containing code
SECTION .text

;--------------------------------------------------------------------
; SerialDPT_Finalize
;   Parameters:
;       DS:DI:  Ptr to Disk Parameter Table
;       ES:SI:  Ptr to 512-byte ATA information read from the drive
;   Returns:
;       CF:     Set, indicates that this is a floppy disk
;               Clear, indicates that this is a hard disk
;   Corrupts registers:
;       AX
;--------------------------------------------------------------------
SerialDPT_Finalize:
        mov     ax, [es:si+SerialServer_ATA_wPortAndBaud]
        mov     [di+DPT_SERIAL.wSerialPortAndBaud], ax

;
; Note that this section is not under %ifdef MODULE_SERIAL_FLOPPY.  It is important to 
; distinguish floppy disks presented by the server and not treat them as hard disks, even
; if the floppy support is disabled.
;
        mov     al, [es:si+SerialServer_ATA_wDriveFlags]
        shl     al, 1
        mov     byte [di+DPT.bFlagsHigh], al
        
        ret

%ifndef CHECK_FOR_UNUSED_ENTRYPOINTS
    %if FLGH_DPT_SERIAL_DEVICE != 0x4 || FLGH_DPT_SERIAL_FLOPPY != 0x10 || FLGH_DPT_SERIAL_FLOPPY_TYPE_MASK != 0xe0 || FLGH_DPT_SERIAL_FLOPPY_TYPE_FIELD_POSITION != 5
        %error "The serial server passes FLGH values into SerialDPT_Finalize directly.  If the flag positions are changed, corresponding changes will need to be made in the serial server, and likely a version check put in to deal with servers talking to incompatible clients"
    %endif
%endif