[3] | 1 | ; File name : IdeRegisters.inc |
---|
| 2 | ; Project name : IDE BIOS |
---|
| 3 | ; Created date : 23.3.2010 |
---|
| 4 | ; Last update : 23.3.2010 |
---|
| 5 | ; Author : Tomi Tilli |
---|
| 6 | ; Description : Equates for IDE registers, flags and commands. |
---|
| 7 | %ifndef IDEREGISTERS_INC |
---|
| 8 | %define IDEREGISTERS_INC |
---|
| 9 | |
---|
| 10 | ; IDE Register offsets from Command Block base port |
---|
| 11 | REG_IDE_DATA EQU 0 ; Data Register |
---|
| 12 | REGR_IDE_ERROR EQU 1 ; Error Register |
---|
| 13 | REGW_IDE_FEAT EQU 1 ; Features Register (ATA1+) |
---|
| 14 | ;REGW_IDE_WRPC EQU 1 ; Write Precompensation Register (obsolete on ATA1+) |
---|
| 15 | REG_IDE_CNT EQU 2 ; Sector Count Register |
---|
| 16 | REG_IDE_SECT EQU 3 ; Sector Number Register (LBA 7...0) |
---|
| 17 | REG_IDE_LBA_LOW EQU 3 ; LBA Low Register |
---|
| 18 | REG_IDE_LOCYL EQU 4 ; Low Cylinder Register (LBA 15...8) |
---|
| 19 | REG_IDE_LBA_MID EQU 4 ; LBA Mid Register |
---|
| 20 | REG_IDE_HICYL EQU 5 ; High Cylinder Register (LBA 23...16) |
---|
| 21 | REG_IDE_LBA_HIGH EQU 5 ; LBA High Register |
---|
| 22 | REG_IDE_DRVHD EQU 6 ; Drive and Head Register (LBA 27...24) |
---|
| 23 | REGR_IDE_ST EQU 7 ; Status Register |
---|
| 24 | REGW_IDE_CMD EQU 7 ; Command Register |
---|
| 25 | REG_IDE_HIDATA EQU 8 ; XTIDE Data High Register (actually first Control Block reg) |
---|
| 26 | |
---|
| 27 | ; IDE Register offsets from Control Block base port |
---|
| 28 | ; (usually Command Block base port + 200h) |
---|
| 29 | REGR_IDEC_AST EQU 6 ; Alternate Status Register |
---|
| 30 | REGW_IDEC_CTRL EQU 6 ; Device Control Register |
---|
| 31 | ;REGR_IDEC_ADDR EQU 7 ; Drive Address Register (obsolete on ATA2+) |
---|
| 32 | |
---|
| 33 | |
---|
| 34 | ; Bit definitions for IDE Error Register |
---|
| 35 | FLG_IDE_ERR_BBK EQU (1<<7) ; Bad Block Detected (reserved on ATA2+, command dependent on ATA4+) |
---|
| 36 | FLG_IDE_ERR_UNC EQU (1<<6) ; Uncorrectable Data Error (command dependent on ATA4+) |
---|
| 37 | FLG_IDE_ERR_MC EQU (1<<5) ; Media Changed (command dependent on ATA4+) |
---|
| 38 | FLG_IDE_ERR_IDNF EQU (1<<4) ; ID Not Found (command dependent on ATA4+) |
---|
| 39 | FLG_IDE_ERR_MCR EQU (1<<3) ; Media Change Request (command dependent on ATA4+) |
---|
| 40 | FLG_IDE_ERR_ABRT EQU (1<<2) ; Command Aborted |
---|
| 41 | FLG_IDE_ERR_TK0NF EQU (1<<1) ; Track 0 Not Found (command dependent on ATA4+) |
---|
| 42 | FLG_IDE_ERR_AMNF EQU (1<<0) ; Address Mark Not Found (command dependent on ATA4+) |
---|
| 43 | |
---|
| 44 | ; Bit definitions for IDE Drive and Head Select Register |
---|
| 45 | FLG_IDE_DRVHD_LBA EQU (1<<6) ; LBA Addressing enabled (instead of CHS) |
---|
| 46 | FLG_IDE_DRVHD_DRV EQU (1<<4) ; Drive Select (0=Master, 1=Slave) |
---|
| 47 | MASK_IDE_DRVHD_HEAD EQU 0Fh ; Head select bits (bits 0...3) |
---|
| 48 | MASK_IDE_DRVHD_SET EQU 0A0h ; Bits that must be set to 1 on ATA1 (reserved on ATA2+) |
---|
| 49 | |
---|
| 50 | ; Bit definitions for IDE Status Register |
---|
| 51 | FLG_IDE_ST_BSY EQU (1<<7) ; Busy (other flags undefined when set) |
---|
| 52 | FLG_IDE_ST_DRDY EQU (1<<6) ; Device Ready |
---|
| 53 | FLG_IDE_ST_DF EQU (1<<5) ; Device Fault (command dependent on ATA4+) |
---|
| 54 | FLG_IDE_ST_DSC EQU (1<<4) ; Device Seek Complete (command dependent on ATA4+) |
---|
| 55 | FLG_IDE_ST_DRQ EQU (1<<3) ; Data Request |
---|
| 56 | FLG_IDE_ST_CORR EQU (1<<2) ; Corrected Data (obsolete on ATA4+) |
---|
| 57 | FLG_IDE_ST_IDX EQU (1<<1) ; Index (vendor specific on ATA2+, obsolete on ATA4+) |
---|
| 58 | FLG_IDE_ST_ERR EQU (1<<0) ; Error |
---|
| 59 | |
---|
| 60 | ; Bit definitions for IDE Device Control Register |
---|
| 61 | ; Bit 0 must be zero, unlisted bits are reserved. |
---|
| 62 | FLG_IDE_CTRL_O8H EQU (1<<3) ; Drive has more than 8 heads (pre-ATA only, 1 on ATA1, reserved on ATA2+) |
---|
| 63 | FLG_IDE_CTRL_SRST EQU (1<<2) ; Software Reset |
---|
| 64 | FLG_IDE_CTRL_nIEN EQU (1<<1) ; Negated Interrupt Enable (IRQ disabled when set) |
---|
| 65 | |
---|
| 66 | |
---|
| 67 | ; Commands for IDE Controller |
---|
| 68 | ;HCMD_RECALIBRATE EQU 10h ; Recalibrate |
---|
| 69 | HCMD_READ_SECT EQU 20h ; Read Sectors (with retries) |
---|
| 70 | HCMD_WRITE_SECT EQU 30h ; Write Sectors (with retries) |
---|
| 71 | HCMD_VERIFY_SECT EQU 40h ; Read Verify Sectors (with retries) |
---|
| 72 | ;HCMD_FORMAT EQU 50h ; Format track |
---|
| 73 | HCMD_SEEK EQU 70h ; Seek |
---|
| 74 | ;HCMD_DIAGNOSTIC EQU 90h ; Execute Device Diagnostic |
---|
| 75 | HCMD_INIT_DEV EQU 91h ; Initialize Device Parameters |
---|
| 76 | HCMD_READ_MUL EQU 0C4h ; Read Multiple (=block) |
---|
| 77 | HCMD_WRITE_MUL EQU 0C5h ; Write Multiple (=block) |
---|
| 78 | HCMD_SET_MUL EQU 0C6h ; Set Multiple Mode (=block size) |
---|
| 79 | HCMD_ID_DEV EQU 0ECh ; Identify Device |
---|
| 80 | HCMD_SET_FEAT EQU 0EFh ; Set Features |
---|
| 81 | |
---|
| 82 | ; Set Features subcommands |
---|
| 83 | HFEAT_SET_XFER_MODE EQU 03h ; Set transfer mode based on value in Sector Count register |
---|
| 84 | |
---|
| 85 | |
---|
| 86 | %endif ; IDEREGISTERS_INC |
---|