| [61] | 1 | XTIDE Universal BIOS v1.1.5 (28 November 2010)
|
|---|
| [43] | 2 | * Errors are now being checked when calling previous INT 13h handler on AH=08h Read Disk Drive Parameters.
|
|---|
| 3 | This fixes infinite drive checking loop on unofficial MS-DOS 7.10 installer.
|
|---|
| [61] | 4 | * Better INT 40h handler detection to fix floppy drive detection with AMI 286/386 BIOS.
|
|---|
| 5 | * AA55h signature no longer required when booting from floppy drives. This should make booter games work.
|
|---|
| [39] | 6 |
|
|---|
| [61] | 7 |
|
|---|
| [36] | 8 | XTIDE Universal BIOS v1.1.4 (24 August 2010)
|
|---|
| 9 | * Correct number of drives is now returned from AH=08h when it is redirected to foreign BIOS.
|
|---|
| 10 | * Interrupt controllers are now unmasked during drive reset.
|
|---|
| 11 | * OS hooks are now enabled for all builds. IRQ waiting no longer uses HLT instruction to fix some EMM386 and VCPI issues.
|
|---|
| 12 | * XT+ build is no more since it would now be the same as AT build
|
|---|
| [32] | 13 |
|
|---|
| 14 |
|
|---|
| 15 | XTIDE Universal BIOS v1.1.3 (1 August 2010)
|
|---|
| [27] | 16 | * v1.1.1 broke booting from foreign drives, it is now fixed.
|
|---|
| [28] | 17 | * Improved error handling a bit.
|
|---|
| 18 | * Longer DRQ and IRQ timeouts to minimize write timouts with some (bad) CF cards.
|
|---|
| 19 | * Default boot menu drive should now be properly selected.
|
|---|
| 20 |
|
|---|
| 21 |
|
|---|
| 22 | XTIDE Universal BIOS v1.1.2 (26 July 2010, no public release)
|
|---|
| [27] | 23 | * Fixed a bug where Disk Parameter Table was accessed with wrong pointer register after writing last block.
|
|---|
| 24 | * Cleaned AH=00h, Disk Controller Reset a bit.
|
|---|
| [26] | 25 |
|
|---|
| 26 |
|
|---|
| 27 | XTIDE Universal BIOS v1.1.1 (19 July 2010)
|
|---|
| 28 | *Booting is now possible from hard disks if floppy controller reset fails
|
|---|
| 29 | since AH=00h, Disk Controller Reset now returns error code for the
|
|---|
| 30 | requested drive only.
|
|---|
| 31 | *Now assembles with Yasm.
|
|---|
| 32 |
|
|---|
| 33 |
|
|---|
| 34 | XTIDE Universal BIOS v1.1.0 (first stable release, 2 May 2010)
|
|---|
| 35 | *Lite and full operating modes
|
|---|
| 36 | *Diagnostic cylinder no longer has to be reserved
|
|---|
| 37 | *Slave drives again work without master present
|
|---|
| 38 | *32-bit transfers for VLB and PCI IDE controllers
|
|---|
| 39 | *16- and 32-bit transfers are enabled on all builds
|
|---|
| 40 | *Boot menu hotkeys for all drives
|
|---|
| 41 | *Drive swapping is handled separately for floppy and hard disk drives so it
|
|---|
| 42 | is now possible to install DOS to any hard disk from any floppy drive
|
|---|
| 43 | *INT 13h,AH=15h return value in DL now longer gets corrupted by drive swapping
|
|---|
| 44 | *Rewritten drive detection and lots of code cleaning
|
|---|
| 45 | *Longer timeout when detecting first drive
|
|---|
| 46 | *Minimum number of floppy drives can be specified if autodetection fails
|
|---|
| 47 | *Maybe other changes that i have forgotten
|
|---|
| 48 |
|
|---|
| 49 | XTIDE Universal BIOS v1.1.0 configuration and flashing program (idecfg.com)
|
|---|
| 50 | *Now works as a generic EEPROM flasher
|
|---|
| 51 | *Improvements to configuration menus
|
|---|
| 52 | *SDP can be completely disabled
|
|---|
| 53 |
|
|---|
| 54 |
|
|---|
| 55 | XTIDE Universal BIOS v1.0.0_RC2
|
|---|
| 56 | *No more boot menu slowdown when no XTIDE Universal BIOS
|
|---|
| 57 | controlled drives present
|
|---|
| 58 | *Hard disks are now reset properly.
|
|---|
| 59 | This fixes some Block Mode related bugs.
|
|---|
| 60 | *Major improvements for error handling
|
|---|
| 61 | *Small improvements for interrupt handling
|
|---|
| 62 |
|
|---|
| 63 |
|
|---|
| 64 | XTIDE Universal BIOS v1.0.0_RC1
|
|---|
| 65 | *Fixed 386+ stack exception bug
|
|---|
| 66 | *Stack is relocated for boot menu even if DPTs are not stored to 30:0h
|
|---|
| 67 | *Strings and boot menu are displayed properly on BIOSes that corrupts
|
|---|
| 68 | AH when returning from INT 10h/AH=Eh
|
|---|
| 69 | *L-CHS addressing is now used for <=504MiB drives even if LBA is supported
|
|---|
| 70 |
|
|---|
| 71 |
|
|---|
| 72 | XTIDE Universal BIOS v1.0.0_b4
|
|---|
| 73 | *Boot menu with drive swapping
|
|---|
| 74 | *Block mode transfers
|
|---|
| 75 | *Cylinder limiting
|
|---|
| 76 | *Drive detection read errors are now properly detected
|
|---|
| 77 | *A little longer timeout value when detecting drives
|
|---|
| 78 | *Minor optimizations to save some bytes
|
|---|
| 79 |
|
|---|
| 80 |
|
|---|
| 81 | XTIDE Universal BIOS beta3
|
|---|
| 82 | *BIOS configuration and flashing program finally available
|
|---|
| 83 | *No more conflicts with other hard disk BIOSes
|
|---|
| 84 | *Slave drives should now be detected without master
|
|---|
| 85 | *Timeouts now use system timer
|
|---|
| 86 | *Variables can now be located to top of base memory
|
|---|
| 87 | *Completely rewritten interrupt handling
|
|---|
| 88 | *Minor optimizations to 8-bit transfers
|
|---|
| 89 | *CTRL can be held down to skip initialization
|
|---|
| 90 | *Late initialization to fix compatibility issues with old systems
|
|---|
| 91 |
|
|---|
| 92 |
|
|---|
| 93 | XTIDE Universal BIOS beta2
|
|---|
| 94 | *AT build and support for 16-bit IDE Controllers
|
|---|
| 95 | *XT+ build for 188/186/V20/V30/286 XTs
|
|---|
| 96 | *Auto detection for timeout values (AT+)
|
|---|
| 97 | *Minor optimizations
|
|---|
| 98 |
|
|---|
| 99 |
|
|---|
| 100 | XTIDE Universal BIOS beta1
|
|---|
| 101 | *Initial release
|
|---|
