[28] | 1 | XTIDE Universal BIOS v1.1.3 (29 July 2010)
|
---|
[27] | 2 | * v1.1.1 broke booting from foreign drives, it is now fixed.
|
---|
[28] | 3 | * Improved error handling a bit.
|
---|
| 4 | * Longer DRQ and IRQ timeouts to minimize write timouts with some (bad) CF cards.
|
---|
| 5 | * Default boot menu drive should now be properly selected.
|
---|
| 6 |
|
---|
| 7 |
|
---|
| 8 | XTIDE Universal BIOS v1.1.2 (26 July 2010, no public release)
|
---|
[27] | 9 | * Fixed a bug where Disk Parameter Table was accessed with wrong pointer register after writing last block.
|
---|
| 10 | * Cleaned AH=00h, Disk Controller Reset a bit.
|
---|
[26] | 11 |
|
---|
| 12 |
|
---|
| 13 | XTIDE Universal BIOS v1.1.1 (19 July 2010)
|
---|
| 14 | *Booting is now possible from hard disks if floppy controller reset fails
|
---|
| 15 | since AH=00h, Disk Controller Reset now returns error code for the
|
---|
| 16 | requested drive only.
|
---|
| 17 | *Now assembles with Yasm.
|
---|
| 18 |
|
---|
| 19 |
|
---|
| 20 | XTIDE Universal BIOS v1.1.0 (first stable release, 2 May 2010)
|
---|
| 21 | *Lite and full operating modes
|
---|
| 22 | *Diagnostic cylinder no longer has to be reserved
|
---|
| 23 | *Slave drives again work without master present
|
---|
| 24 | *32-bit transfers for VLB and PCI IDE controllers
|
---|
| 25 | *16- and 32-bit transfers are enabled on all builds
|
---|
| 26 | *Boot menu hotkeys for all drives
|
---|
| 27 | *Drive swapping is handled separately for floppy and hard disk drives so it
|
---|
| 28 | is now possible to install DOS to any hard disk from any floppy drive
|
---|
| 29 | *INT 13h,AH=15h return value in DL now longer gets corrupted by drive swapping
|
---|
| 30 | *Rewritten drive detection and lots of code cleaning
|
---|
| 31 | *Longer timeout when detecting first drive
|
---|
| 32 | *Minimum number of floppy drives can be specified if autodetection fails
|
---|
| 33 | *Maybe other changes that i have forgotten
|
---|
| 34 |
|
---|
| 35 | XTIDE Universal BIOS v1.1.0 configuration and flashing program (idecfg.com)
|
---|
| 36 | *Now works as a generic EEPROM flasher
|
---|
| 37 | *Improvements to configuration menus
|
---|
| 38 | *SDP can be completely disabled
|
---|
| 39 |
|
---|
| 40 |
|
---|
| 41 | XTIDE Universal BIOS v1.0.0_RC2
|
---|
| 42 | *No more boot menu slowdown when no XTIDE Universal BIOS
|
---|
| 43 | controlled drives present
|
---|
| 44 | *Hard disks are now reset properly.
|
---|
| 45 | This fixes some Block Mode related bugs.
|
---|
| 46 | *Major improvements for error handling
|
---|
| 47 | *Small improvements for interrupt handling
|
---|
| 48 |
|
---|
| 49 |
|
---|
| 50 | XTIDE Universal BIOS v1.0.0_RC1
|
---|
| 51 | *Fixed 386+ stack exception bug
|
---|
| 52 | *Stack is relocated for boot menu even if DPTs are not stored to 30:0h
|
---|
| 53 | *Strings and boot menu are displayed properly on BIOSes that corrupts
|
---|
| 54 | AH when returning from INT 10h/AH=Eh
|
---|
| 55 | *L-CHS addressing is now used for <=504MiB drives even if LBA is supported
|
---|
| 56 |
|
---|
| 57 |
|
---|
| 58 | XTIDE Universal BIOS v1.0.0_b4
|
---|
| 59 | *Boot menu with drive swapping
|
---|
| 60 | *Block mode transfers
|
---|
| 61 | *Cylinder limiting
|
---|
| 62 | *Drive detection read errors are now properly detected
|
---|
| 63 | *A little longer timeout value when detecting drives
|
---|
| 64 | *Minor optimizations to save some bytes
|
---|
| 65 |
|
---|
| 66 |
|
---|
| 67 | XTIDE Universal BIOS beta3
|
---|
| 68 | *BIOS configuration and flashing program finally available
|
---|
| 69 | *No more conflicts with other hard disk BIOSes
|
---|
| 70 | *Slave drives should now be detected without master
|
---|
| 71 | *Timeouts now use system timer
|
---|
| 72 | *Variables can now be located to top of base memory
|
---|
| 73 | *Completely rewritten interrupt handling
|
---|
| 74 | *Minor optimizations to 8-bit transfers
|
---|
| 75 | *CTRL can be held down to skip initialization
|
---|
| 76 | *Late initialization to fix compatibility issues with old systems
|
---|
| 77 |
|
---|
| 78 |
|
---|
| 79 | XTIDE Universal BIOS beta2
|
---|
| 80 | *AT build and support for 16-bit IDE Controllers
|
---|
| 81 | *XT+ build for 188/186/V20/V30/286 XTs
|
---|
| 82 | *Auto detection for timeout values (AT+)
|
---|
| 83 | *Minor optimizations
|
---|
| 84 |
|
---|
| 85 |
|
---|
| 86 | XTIDE Universal BIOS beta1
|
---|
| 87 | *Initial release
|
---|